Any machine will have various problems during use, some of which are caused by the improper human operation, some may be caused by the machine being used for a long time, and some parts may be insensitive.

The coal briquette machine cannot avoid failures during the use and operation. At this time, it is necessary to stop and analyze the reasons. If the machine is used continuously, these failures will affect the service life of the coal rod machine. So, which faults have a greater impact on the life of the coal briquette machine? What are the solutions?

Next, we will give you a summary, and I hope you will try to avoid it when you use the coal briquette making machine in the future.

Common mechanical failures

1. After using the machine for a period of time, the staff should check the bearings. The bearing of the coal rod machine is damaged or does not operate normally, which will increase the load of the motor, and it is easy to burn out the motor for a long time.
2. If the pulverized coal in the coal briquette machines were not cleaned up when the machine was shut down last time, the pulverized coal in the machine has become dry and hard after a long time. Such things are stored in the body of the coal briquette machine and will be stored next time. If the load is too large, it will cause blockage and it will not be easy for normal production.
3. For convenience, some workers did not fully mix the pulverized coal with water and binder, resulting in the pulverized coal being dry and uneven in moisture. The internal parts wear a lot, and it will fail after a long time, which will affect the life of the coal rod machine.
4. Due to the chaotic factory environment and poor management, hard things such as iron and bolts are mixed into the machine, which will damage the internal parts of the coal briquette making machine and seriously affect the life of the coal rod machine.

Solutions of above mechanical failures

1. The factory should check the bearings of the coal rod machine on time to see if there is any damage, and the old parts should be replaced in time to avoid affecting the normal operation of the machine.
2. After each use of the machine, it is necessary to clean up the residual coal powder in the machine in time to prevent the coal powder from drying out and agglomerating, which will affect the normal operation of the machine. Relevant staff can formulate some supervision and management measures to ensure that employees can not only use the machine normally but also pay attention to the maintenance and cleaning of the machine.
3. If you want to make good-quality coal rods, you can’t be lazy. It is an indispensable step to mix pulverized coal with a certain proportion of water and binder and mix them well with a coal mixer. Our factory has a complete coal briquette production line with complete steps, which is the best machine for making coal rods.
4. For the situation that the factory environment is chaotic and poorly managed, and hard things such as iron and bolts are mixed into the machine, the factory management should formulate relevant regulations to punish the employees who cause the damage to the machine. What’s more important is to standardize the location of machines in the factory, and manage raw materials, machines, parts, etc. in an orderly manner.